Noncompliance with FMVSS No. 126, “Electronic Stability Control Systems”
The contents of this forum are for experimental & educational purposes only. As such, it is not acceptable whatsoever to publish any software that is bound by any legal restriction.
NONCOMPLIANCE
The brake fluid used during the production of the potentially affected vehicles may have contained excess moisture. Excess moisture in brake fluid may cause a gelatinous material to form in the brake system. This material may accumulate and temporarily clog stability control-related valve filter(s) in the Vehicle Dynamics Control (VDC) system. In this situation, VDC performance may not fully comply with the FMVSS No.126 requirement. However, the brakes will continue to operate normally
SAFETY RISK
If a stability control-related valve filter becomes temporarily clogged as described above, the system might exhibit reduced yaw rate control. In certain situations, when the VDC system is activated, it may not be as effective in preventing loss of vehicle control, which may increase the risk of a crash.
THE REMEDY
Retailers will perform an ABS sequence control (activation), then flush and replace the brake fluid in all potentially affected vehicles.
VEHICLES
Not all vehicles in the VIN ranges listed below are affected by this campaign. Coverage for all affected vehicles must be confirmed by using the Vehicle Coverage Inquiry function on subarunet.com. This data will be available in the system before owner notification begins.
comment
Posted by3 years ago
Archived
Allscanner VXDIAG Multi Daignostic Tool for Suburu SSM III SSM 3 software has newly updated to V2015.10 in obd365.com (2016-01-22).
Support Multi-language: English/ German/ Spanish/ French/ Italian Compliant with 12V and 24V communications.
Hardware: VXDIAG Multi Tool for Subaru (only) http://www.obd365.com/wholesale/vxdiag-multi-ssm-iii-diagnostic.html
SUBARU SSM-III Software Functions:
All System Diagnosis. Selecting this item displays on a single screen the fault detect status of all control system control modules for which SSMΙΙΙ diagnosis is supported, and memorized diagnostic codes.
Each System Check. Selecting this item makes it possible to select a particular system from among the control systems forwhich SSMΙΙΙ diagnosis is supported, and perform fault diagnosis. This item can be used to view input/output data of the system control modules that perform fault diagnosis, memorized diagnostic codes, and other data on the PC display. This menu item is also used after repair work is complete to delete diagnostic codes, to configure control module settings, etc.
Saved Data Display. This item can be used to save various data sampled during fault diagnosis operations, and to load data for viewing after work is complete.
Immobilizer. This item performs immobilizer registration.
Reprogram. This item performs reprogramming of the control module.
Read CF application measurement data. This item performs reading stand alone measurement data saved in a CF card to hard disk of your PC.
Convert/Save measurement data on driving recorder. Loads data sampled on the driving recorder to the PC from the CF card, and converts and saves that data.
Oscilloscope. After attaching the optional pulse/analog cartridge to SDI, connect the pulse/analog box to the SDI and using pulse/analog probe to perform analog sampling.